Description
This product is a microwave sensor that can be installed on AlcaPower 930233 UFO100E and 930234 UFO150H projectors. The functions of this device are: presence sensor, twilight sensor and dimmer.
The 930233 UFO100E and 930234 UFO150H projectors have the sensor attachment installed in the center of the reflector.
To install the sensor:
• Unscrew the closing cap of the coupling connector located in the center of the UFO projector.
• Insert the sensor jack connector into the coupling connector.
• Screw the sensor to the coupling connector.
Without using the UFO presence sensor remote control, supplied separately as an optional accessory, the sensor cannot be adjusted and only works with the following factory settings:
• Detection distance: 100%.
• Stand-by interval: 0s (disabled).
• Twilight sensor: disabled.
How it works:
• When the sensor detects movements and the ambient light is below the twilight threshold, or the twilight function is disabled, the projector turns on at the light intensity set by the dimmer function (10%~100%) for a time equal to the set ignition interval.
• Once the switch-on interval has passed, if the sensor does not detect movements it goes into stand-by for the set stand-by time interval and the projector lights up at the intensity set for the stand-by interval (10% or 30%). Once the stand-by interval is over, the projector turns off.
For more information, consult the technical sheet HERE.
