15watt/meter cob RGB led strip must be powered at 12V. The rgb coloring allows you to vary the preferred light color using the appropriate controller.
The cob led strip is a new generation led strip that allows, in fact, to have a single line of light, eliminating the "dots" that are annoying to the eye.
Power: 15W/m. Number of LEDs: 840 LEDs/m.
This product is a decorative RGB COB LED strip with which you will be able to carry out the most varied lighting projects with great satisfaction.
Each LED strip must be applied to an aluminum profile to dissipate heat and extend the life of the LED strip.
This LED strip has an opening angle of the light thanks to which it is possible to have a 180° light, with a fairly diffused beam.
Where can I place my 15W/mt rgb led strip?
It is a LED strip with an adhesive back, essential for gluing the LED strip onto an aluminum profile and dissipating its heat. The 15 w/mt rgb led strip is suitable for creating various kinds of atmospheres. It is generally used for a soft and ambient light, in living rooms, bedrooms or rumpus rooms.
It is recommended to install the LED strip in a dissipating aluminum profile. HERE you can find all available aluminum profiles.
This type of LED strip can only be used indoors, the degree of protection is IP20.
The rgb led strip can be cut, along the appropriate line, every 5cm. Coil size: 10x1.6x5000mm.
The led strip requires a 12 Volt power supply, therefore it needs a power supply, which you can find HERE.
The Rgb led strip is dimmable, i.e. it is possible to vary the intensity of the light, and in this case, also the color of the light with the appropriate controller that you can find HERE.
Note: You can also directly power the RGB strip without using a controller. In this case, connect the black wire to the positive pole of the power supply and, depending on the type of light you want to obtain, connect 1, 2 or all 3 of the remaining wires relating to the red (R), green ( G) and blue (B) to the negative pole of the power supply. Keep in mind that with this power mode the colors that can be obtained are limited compared to those achievable with an RGB controller.