14watt/meter RGBIC digital cob led strip must be powered at 24V. The dynamic function allows you to vary the color of the light and the preferred play of light using the appropriate controller.
The cob led strip is a new generation led strip that allows, in fact, to have a single line of light, eliminating the "dots" that are annoying to the eye.
Power: 14W/m. Luminous flux per metre: 350lm max.
This product is a decorative RGBIC digital COB LED strip with which you will be able to carry out the most varied lighting projects with great satisfaction.
Each LED strip must be applied to an aluminum profile to dissipate heat and extend the life of the LED strip.
This LED strip has an opening angle of the light thanks to which it is possible to have a 180° light, with a fairly diffused beam.
Where can I place my 14W/mt digital rgbic led strip?
It is a LED strip with an adhesive back, essential for gluing the LED strip onto an aluminum profile and dissipating its heat. The 14 w/mt digital led strip is suitable for creating various kinds of atmospheres.
It is recommended to install the LED strip in a dissipating aluminum profile. HERE you can find all available aluminum profiles.
This type of LED strip can only be used indoors, the degree of protection is IP20.
The digital led strip can be cut, along the appropriate line, every 10cm. Coil size: 12x1.6x5000mm.
The led strip requires a 24 Volt power supply, therefore it requires a power supply, which you can find HERE.
The Digital LED strip is dimmable, i.e. it is possible to vary the intensity of the light, and in this case, also the color of the light with the appropriate controller that you can find HERE.
NOTE: for lengths greater than 8m, divide the series into two or more parts of a maximum of 8m, connect them in parallel and feed them directly from the power supply by connecting +DC24V to the positive pole and GND to ground.
Only the DO data line and GND must be connected to the controller.