Description
2-metre angular aluminum profile kit to be smoothed out of the plasterboard with satin cover and end caps.
The angular aluminum profile is used for the correct dissipation of the LED strips.
How can I use the angular aluminum profile to be smoothed in the plasterboard?
The flat aluminum profile is used for correct dissipation of the LED strip, thanks to which the LED strip will have a longer life.
The steps for applying the flat profile are:
1- Install the profile by screwing it to the plasterboard plate in a corner of your room,
2- Trim the profile flush,
3- Paste the led strip inside the flat profile in no cover,
4- Make sure it is carefully glued, even the beginning and the end, if it doesn't adhere perfectly, put a drop of glue on the back of the strip,
5- Take the cable out of the perforated cap,
6- Close with the satin cover,
7- Connect your 24 volt led strip to the power supply and your profile led strip is ready!
Where can I apply the LED strip with the retractable corner aluminum profile including the satin cover?
Its ideal application is to create blades of light in the corners of modern environments such as residential premises or offices.
The profile is screwed to the plasterboard and subsequently trimmed flush, in this way you will only see the cut of light protected by a satin cover.
A solution for greater design and extraordinary linearity.
With the choice of the right led strip you will have an amazing result.
It helps to protect against dust and external agents thus obtaining a better aesthetic result for greater cleanliness.
In the kit you will find: 2 meters of retractable anodized aluminum flat profile, 2 meters of satin cover and 2 caps.
Our corner profile is suitable to support a led strip with a maximum power of 28 watts/meter.
Led strip not included.
Minimum purchasable quantity: 2 bars.
| MAXIMUM SUPPORTED POWER: | 28 watt/mt |
| PROFILE COLOUR: | Satin Aluminium |
| DIMENSION: |
Overall width 50,2 mm Height 13,1 mm Inner width 9,5mm |
| NOTES: |
IP20 |
